DioxinMonitoringSystem®

Complete Surveillance of Dioxin Emissions

Technical Data


Design:
for industrial use

Sampling Method

Standard reference: dilution method in full accordance to EN1948-1:(2006), extended for long term sampling
Filter System: 3 stage dry solid filters, separating dust and gas fraction
Sampling Probes: 2 special heated titanium zero-pressure probes

(for very small gas channels also with only one probe available)

Sampling Intervall: usually 4 weeks (2 hours to 6 weeks)

(to measure I-TEQPCDD/F)

Range of method:

 

6 hours 0,01 - 100 ng TEQ/m³
6 weeks 0,0001 - 10 ng TEQ/m³

(depending on laboratory parameters)

Isokinetic Control: direct at each actual sampling position
Remote Control: Internet-TCP/IP4

Operating Environment

Temperature: -10 to +45 °C
Humidity: 10 - 90 % relative, not condensing

Physical Dimensions

Control Unit: 62/62/171 cm (w/d/h)
Outer Sampling Unit: 52/28/60 cm (w/d/h) - outside the stack
Inner Sampling Unit: depending on length of probes - inside the stack
Heated Tube: length up to 70 m

Gas Parameters

Velocity: 2 to 20 m/s (up to 35 m/s)
Temperature: up to 250°C (up to 450°C) *)
Humidity: up to 350 g/m³ *)
Dust Content: 0-20 mg/m³ (up to 150 mg/m3)
Corrosive Gases: limited according to layout
  *) due to interdependence cross influence, these parameters have to be taken into consideration together

External Supply

Main Power: 400 V 16 A, 3 phases + neutral + ground

alternatively

  230 V 16 A, 1 phase + neutral + ground

for a maximum length of the tube of 12 meters

Compressed Air: typical consumption: 2-6 m³/h dependent on humidity

Other

Maintenance Interval: typically 12 months (dependent on application)
Installation:  outdoor or indoor 

MonitoringSystems®  GmbH, 3021 Pressbaum, Austria

The data shown on this page are to be used for the business in the interest of MonitorinSystems GmbH and their distributors only.
Any use, storage and automatic processing of the contact data, e.g. for advertisement mailings, is strictly prohibited.